

As a man I can assure you that this pill wouldn’t be feasable for me to take and I’m better off without it.
~Because I’m snipped~
As a man I can assure you that this pill wouldn’t be feasable for me to take and I’m better off without it.
~Because I’m snipped~
Biblically accurate infant.
Land of the Free™~(Terms and conditions apply.)~
Yes? If I could get everything in one place then I would happily pay for that. I don’t pirate to save money. Saving money is just a nice sideeffect. I pirate because it’s literally more convenient than juggling 15 different services.
Overthinking has to be my favorite hobby.
Mine is a ball python. They seem to prefer basking under the heat lamp after eating. Also they haven’t ever pooped in their water dish that I can remember, but I have had them horf up a partially digested rat in there before. That incident was made even more pleasant by the fact that I had their heat lamp positioned over the water dish at the time (to try and keep humidity up) and it happened while I was sleeping so I didn’t catch it for several hours. So I awoke to my entire house being filled with the miasma of a partially digested rat which had been stewing under a heat lamp for several hours. The smell was indescribable and beyond the imagination of any sane individual.
Unfortunately I don’t think the $20 I have in the bank right now will cover the cost of the test rig.
Oh yeah, basically the easiest way to do it would to pump water out of each basin, through a heat exchanger, and then back into the basin. That way you could have your whole temp control aparatus located outside of the terrarium. Plus that would also easily enable automatic water level management to keep the water levels identical. For your heat exchanger you could just use a CPU water block and a peltier device. You regulate the power going to the peltier device by monitoring a temp sensor in your water return pipe and just pulsing the peltier device on and off at different rates to control the heating or cooling rate. Plus with the peltier device you can just reverse the polarity to switch from heating to cooling to enable the shuffling of the basins. All of this would be controlled and charted in a csv file by a raspberry pi. Additionally you could connect a simple motion sensor so the pi could flag the times the snake was using one of the basins to make it easier to read the data.
Rather than monitoring ambient temp or humidity you would probably be better off just keeping them tightly controlled and constant via other systems. That would further reduce variables for the initial test.
Snake tax. Here’s the little turd the one time they decided to get stuck in my couch. They were perfectly fine but I had to partially dismantle my couch to get them out.
That’s an interesting point. I grew up with well water in MN where our ground water temp is about 43F (6C) so I am used to practically ice cold water just being on tap. It makes sense that what you like is going to vary based on what you’re used to.
I have been thinking that all day. But to do it properly I need a bigger terrarium and some more supplies. You can’t have the dishes be different sizes or that’s an additional variable. But I also want to keep a big enough dish that they can soak in it. They never actually do because I keep the humidity high enough but they should still have the option.
So I need to have a large terrarium with several identical water basins all in the same area. 3 basins would work (warm, room temp, and cool) but ideally I would have several set to various specific temps. Each basin should be able to be heated and cooled to reach a set water temp and which basin has which temp of water needs to be shuffled ocasionally to eliminate selection based on exact basin location or similar variables. That heating and cooling could easily be acheived with a peltier module and a temp sensor on each basin linked to a controller. You would also need a camera to view which basin the snake actually uses.
Of course I already know what would happen. I would spend a couple hundred dollars setting all that up only to learn that my single braincell possessing snake would only ever use the closest basin.
Rename it to Mexico. Then the whole gulf of mexico situation is fixed.
If I have to break out anything more than a plate/bowl and utensils then it’s cooking.
I mean, fair though. I would never want anyone looking at my code either.
I’ll take a little sulphur over the radioactive poisoning…
I swear if I have to explain nuclear fuel disposal one more time!
from coal plants
Never mind. You get to live.
If he had the right plumbing then a zip tie would have also worked.
Yes but if you reply to a clone bot, it’s not like the clone bot is going to reply to you back. The fact that replies are cloned doesn’t change the fact that noone is actually there and you’re just talking to a wall. I use social media to interact with people. If I wanted to see redit posts and not interact with people then I would just browse reddit without an account.
It has been done several times and the concensus has always been that people hate it. Check out lemmit. They do exactly that and because of it most instances have defederated from them.
Lemmy doesn’t have the userbase of reddit. If you start just cloning posts from reddit then pretty soon everyones all feed only consists of dead bot made posts. Cloning shit from reddit just turns lemmy into a ghost town.
We always used them for target practice. They need to be punctured for disposal anyways, you know when you hit one, and They’re about the right size for sighting in on a 100yd range.
But the same thing can happen with vasectomies so why isn’t it showing anything there?